Matilda Rattan Bedside

• Insert the four feet into the pre-drilled holes on the bottom of the bedside cabinet. 
• Secure each foot by turning it clockwise until tight.

1. Attach the anti-tilt bracket (E) to the back of the bedside cabinet using two screws (C). 
2. Add the bracket left or right to suit the position of the cabinet.
3. Ensure the bracket is aligned with the pre-drilled holes and secure it tightly with a Phillips screwdriver.

1. Use a pencil (J) to mark the position for the wall-plug (F) on the wall, aligning it with the anti-tilt bracket (E) already attached to the cabinet.
2. Fit the wall bracket a little lower than the one on the cabinet.

1. Using the handheld electric drill (I), carefully drill a hole into the wall at the marked position for the wall-plug (F). 
2. Ensure the drill is perpendicular to the wall for an accurate and secure fit. 

Note: Be careful and please make sure there are no pipes or electric cables in the area being drilled.

1. Insert the wall-plug (F) into the drilled hole in the wall. 
2. Use a hammer (H) to gently tap the wall-plug until it is flush with the wall surface, ensuring a secure fit.

1. Attach the anti-tilt bracket (E) to the wall by aligning it with the wall-plug (F) and securing it using two screws (G). 
2. Use a Phillips screwdriver (K) to tighten the screws, ensuring the bracket is firmly fixed to the wall.

Secure the cabinet to the wall by attaching the tie for the anti-tilt bracket (D) to the bracket on the wall.

Ensure the tie for the anti-tilt bracket (D) is securely fastened to both the cabinet and the wall bracket. This will stabilize the cabinet and prevent it from tipping over.

1. Attach the handles (A) to the front of each drawer by aligning them with the pre-drilled holes. 
2. Secure each handle using two screws (B) and tighten with a Phillips screwdriver (K).